BLVSK - PRORECO MARINE RUBBER CALK ONE-PART SEALANT
- MSDS: BLVSK
- Manufacturer: PRODUCTS RESEARCH AND CHEMICAL CORP
- Product Name: PRORECO MARINE RUBBER CALK ONE-PART SEALANT
- National Stock Number: 8030-00N022236
Product Identification
Product ID:PRORECO MARINE RUBBER CALK ONE-PART SEALANT
MSDS Date:11/27/1989
FSC:8030
NIIN:00N022236
MSDS Number: BLVSK
Responsible Party
GLENDALE, CA 91209
US
Emergency Phone: 800-228-5635;800-424-9300(CHEMTREC)
Info Phone: 818-240-2060
Preparer: CH
Cage: DO563
Contractor
Telephone: 818-240-2060
Cage: DO563
Ingredients
2-BUTANONE; (METHYL ETHYL KETONE)
CAS: 78-93-3
RTECS: EL6475000
Fraction By Weight: <5%
OSHA PEL 200 PPM;300 PPM STEL
ACGIH TLV: 200 PPM;300 PPM STEL
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
PHTHALIC ACID, DIISODECYL ESTER; (DIISODECYL PHTHALATE)
CAS: 26761-40-0
RTECS: TI1270000
Fraction By Weight: 10%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: IRRITATION. SKIN: LOCAL
IRRITATION. MAY CAUSE ALLERGIC SKIN RASH IN SENSITIZED INDIVIDUALS.
INHAL: IRRITATION TO NOSE AND THROAT. MAY CAUSE HEADACHE, DIZZINESS
AND UNCONSCIOUSNESS. INGEST: MAY C AUSE NAUSEA, VOMITING, LIVER AND
KIDNEYDAMAGE.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYES: FLUSH WITH LUKEWARM WATER FOR AT LEAST 15 MIN. IF
SYMPTOMS PERSIST, CONSULT PHYS. SKIN: WASH WITH SOAP AND WATER. IF
SYMPTOMS PERSIST, CONSULT PHYS. INHAL: REMOVE TO FRESH AIR. INGEST:
CONSULT P HYS.
Fire Fighting
Flash Point Method:PMCC
Flash Point:88.0F,31.1C
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE KNOWN.
Accidental Release
Spill Release Procedures:REMOVE ALL IGNITION SOURCES. SCOOP INTO
CONTAINERS. CLEAN-UP RESIDUE WITH 1,1,1-TRICHLOROETHANE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:NONE SPECIFIED BY MANUFACTURER.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Exposure Controls
Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE
FOR EXPOSURE OF CONCERN .
Ventilation:GENERAL VENTILATION TO MAINTAIN VAPOR BELOW PEL.
Protective Gloves:SOLVENT RESISTANT GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NBR: ALL COLORS.
Chemical Properties
HCC:F4
Vapor Density:2.42(MEK)
Spec Gravity:1.5
Evaporation Rate & Reference:5.7(MEK)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Stability
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:OXIDES OF CARBON.
Disposal
Waste Disposal Methods:EPA WASTE NO. D-001. DISPOSE OF SPILLAGE IN
COMPLIANCE WITH FEDERAL, LOCAL AND STATE REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.